Services
What the shop does for a plant
Maintenance first, controls second, and the electrical work in between. All of it is done by our own people, under our own lockout program or yours.
Motors, starters and drives
Troubleshooting, replacement and parameter backups for the equipment that moves product.
Motor control center buckets and starters
Variable-frequency drives and soft starters
Motor testing and alignment checks
Controls and PLC panels
Panel repairs, retrofits and small builds, with drawings updated when we leave.
Fault finding on sensors, relays and I/O
Program backups before any change
As-built drawings handed over
Distribution and switchgear
Planned-outage work on the gear that feeds the plant.
Cleaning, torque and trip tests
Breaker and relay test records
Arc-flash label updates
Line moves and new hookups
Power and control wiring when equipment is added, moved or retired.
Conduit, tray and wire to the machine
Disconnects, e-stops and guarding circuits
Start-up support with the installer
Older equipment
Many plants run gear older than the people maintaining it. We keep it safe and tell you plainly when a part is past saving.
Obsolete part searches and substitutions
Replacement plans written by priority
When a line stops
Plant-down calls, day or night
A lead electrician or controls technician takes the plant-down line. After-hours calls follow the overtime terms in your service agreement.
Fault finding first
We find what stopped the line before we replace anything.
Lockout before repair
The six steps apply at 3 a.m. the same as at 3 p.m.
A short written report
What failed, what we did and what to order, left with your shift lead.
Not sure where to start?
Start with a plant walk
A lead electrician walks the plant with your maintenance supervisor, writes down what we see and sends it back. No price comes before that.